Cuff Assembly
Buckle:
1.0W x 1.0L x 0.25H inches. Gray, Adjustable with positive lock, stainless steel
back plate. Standard male 5/32" snap (0.154 inch, 4mm); provides 360o performance.
Patented, Easily adjusted buckle incorporating a positive fabric lock to eliminate
slip and enhance skin contact. Non-sensitizing stainless steel back plate.
Fabric:
0.85 inches wide. Grey, knit incorporating silver plated filament and elastic
nylon. Insulative outer cuff surface, conductive inner cuff surface.
Size/Length:
Nominal 6.5" After stretching to 2x length and relaxing.
Adjustable:
Easily adjustable to fit all personnel.
Control:
Date coded and Prostat manufacturer's logo embossed on all cuff assemblies
“M" series cuffs:
Incorporate a 10mm male snap and insulated snap cover installed in the fabric
approximately 1.5 inches from the cuff buckle. The 10mm snap is used to mount
and ground the Prostat PFM-711A Field Meter and CPM-720A Charge Plate Monitor.
Cord Assembly
Cord:
Heavy Duty, Lightweight construction of Single bundle, laced tensile conductors
reinforced with synthetic fibers. Cord Diameter: 0.06" Coil Diameter: 0.26"
Alligator clip supplied.
Resistor:
One megohm (±10%) resistor molded into snap connection
Ground Connection:
Standard banana plug
Warranty:
Warranted for One Year against mechanical and electrical defects.
Cord Extension:
Full extension greater than 13 feet; Working Length greater than 10 feet.
Tested:
Provides over 100,000 bending cycles per EOS/ESD-S1.0-1987 procedures.
WARNING:
A one-megohm resistor has been molded into the plastic cap on the ground cord
fastener. DO NOT REMOVE. If it becomes damaged, replace ground cord immediately.
Do not use in areas where the individual may come in contact with electrical
circuits exceeding 250 volts.
CAUTION:
The Prostat wrist strap is for static control. It will not reduce or increase
your risk of receiving electrical shock when using or working on electrical
equipment. Follow the same procedures you would use without wrist straps, including:
* Make certain that equipment having a grounding type plug is properly grounded.
* Make certain that you are not in contact with grounded objects other than
through the strap.